|
2 Watt Stereo Amplifier
Kit
This is a 1 watt per channel, stereo amplifier module Kit using two LM386N IC’s from
National Semiconductor. It is basically two of
our CK700’s on a single PC board, with a dual gang
pot. It will operate best from 6-12V DC and will work well from a battery since the quiescent current
drain is only 10 mA. It requires no heat sinks for
normal use. The input and output are both ground referenced. Maximum output will be obtained with a
12V power supply and 8 ohm speaker, however it is particularly suitable for driving headphones from a
supply as low as 4V.
Specifications:
- L: 2-1/2" W: 1-3/8" H: 1"
- Requires external 4-12 volt dc
(Need a Power Supply?)
- Power output : > 1 Watt max. @ 8 ohms, 12V DC ~ 0.4 Watt RMS cont. per channel
See
K115V2.pdf for complete
details, including schematic and theory of operation. Requires
Adobe Acrobat Reader available at
www.adobe.com
for FREE!
Click here to see a
listing of all our amplifier kits and modules
|
