|
HD2COMBO
(click picture to enlarge)
Board Layout:
 |
This two channel RF Remote Control Relay Board is an improved
version of our original CK1617 unit. It still uses an auto roll algorithm which makes it almost impossible to steal the code for unauthorized use.
It has 2 relays (channels) that are individually jumper selectable as either
latching or momentary. Each channel has a reset connection, so you could
use a limit switch to reset the relay if you desired. Each channel has led indicators. Receiver can
support up to 15 transmitters. This unit makes
remote control very affordable for you next project.
Specifications:
- Range is over 250 feet.
- Transmits on 433.9 MHz
- Transmitter includes battery.
- Receiver Power 12 VDC (power supply not included)
(Need a Power Supply?)
- Circuit draws 9mA in idle state, 1 relay energized 40mA and
2 relays energized draws 70mA.
- Relays have a Common, Normally Closed (NC), and Normally Open
(NO).
- Each relay has a reset wiring option for use to reset the relay with a
limit switch. (i.e. Garage Door Opener, set relay to latching mode,
relay is energized powering door motor, door trips a travel limit switch
that is wired back to the relay board turning the relay off.)
- Each Individual Relay is jumper selectable latching or momentary.
- PCB Board Amperage
Rating: 10A
- Relay Contact Ratings: 24VDC@10A, 250VAC@10A, 120VAC@10A.
(more
info on how relays work)
- Transmitter Dimensions 2-1/4" L x 1-1/2" W x 1/2"
D
- Receiver Board Dimensions 3-3/8" L x 2-3/8" W x
7/8" H
HD2COMBO Programming
instructions: Apply power to the correct terminals (+ and -), press both the
"learn" button on the receiver board and the "1" button on the remote
transmitter and hold for only 1 second, let go of both buttons, wait 20 seconds,
you are now good to go and the RX and TX are paired together. The board
will appear to be "dead" until the learning process is accomplished. The
data light will flash only when a "learned" transmitter button is pushed.
The RED LED lights on the board will only activate when a learned transmitter
button is pushed. Please call us at 866-664-0627 if you need assistance.
See
R2D.pdf for complete
details, including schematic and theory of operation. Requires Adobe
Acrobat Reader available at
www.adobe.com
for FREE!
|
