Product Description
4 Channel Auto Roll RF Relay Board Assembled – CK1616A – DISCONTINUED by manufacturer
This 4 Channel Auto Roll RF Relay Board is assembled and includes resets on the board so you can use a switch to reset the relay when using toggle mode. This is handy for applications like a garage door where you would want the motor to stop when the door is closed or open all the way. DIY K180v3
This 4 channel remote control relay board is available as a soldering kit. The relay board uses “Rolling Code” so it is nearly impossible to crack. Features pre assembled and aligned RF modules, pre assembled key-chain transmitter that only requires you to solder battery clips and case. Receiver requires component mounting & soldering. Receiver can “learn” up to 16 transmitters. Transmitters can be used with multiple receivers. 4 channel output with Single Pole Double Throw (SPDT) relays rated 10A @ 28VDC. Each output can independently be made latching (Push-on/Push-off) or momentary. Range exceeds 50meters. Transmitter uses 12V cell (included). Ideal for higher security garage doors, auto gates, electric locks etc.
Specifications:
- Range is over 50 Meters (~150 feet).
- Transmits on 433.9 MHz
- Transmitter comes fully assembled and includes battery.
- Receiver Power 12 VDC (power supply not included). (Need a Power Supply?)
- Circuit draws 8mA in idle state, 1 relay energized 44mA, 2 relays 78mA, 3 relays 111mA, and 4 relays 144mA.
- Relays have a Common, Normally Closed (NC), and Normally Open (NO).
- Each Individual Relay is jumper selectable latching or momentary.
- Relay Contact Ratings: 240VAC 7Amps, 125VAC 10Amps, 28VDC 10Amps.
- Has 4 resets for each relay.
- Includes transmitter and receiver.
- Transmitter Dimensions 2-1/4″ L x 1-1/2″ W x 1/2″ H
- Receiver Dimensions 3-3/8″ L x 3″ W x 1″ H
- NOT COMPATIBLE WITH OUR HD4RX or HD4TX
Reviews
There are no reviews yet.